Network-computing-devices Wireless Ethernet Adapter GW-EN11H Bedienungsanleitung PDF herunterladen (Seite 19)

GeoWave GW-EN11H Wireless Ethernet Adapter User's Manual

The Wireless Tab

Operating Mode: lets you select the

network scenarios, either Ad-Hoc or

Infrastructure. Default setting is

“Infrastructure”

SSID: lets you set the Service Set

Identifications:

Default SSID is “Any”. When set to

any, the adapter is allowed access to

any nearby AP.

Channel: enables you to select a

transmission channel.

Transmission Rate: displays a list

of transfer rates.

Access point density: enables you

to set the relative number of access

points near the GW-EN11H. Use this

setting to reduce channel overlap

and interference:

• Low: 1-2 nearby APs

• Medium: 3-4 nearby APs

• High: 5 or more nearby APs

When connected in an infrastructure

or ad-hoc mode, a list of nearby APs

or peers is displayed at the bottom of

the Info screen. When you re-load

the web page, the list will be

updated.

WEP enabled: Allows you to enable

or disable Wired Equivalency Privacy

(WEP) for encryption, with either 64-

or 128-bit encryption.

WEP key length: Enables you to

choose either a 64- or 128-bit

encryption scheme. Be sure that

the adapter’s WEP key must be the

same as the AP’s, otherwise adapter

still can not communicate with

wireless LAN.

Note: Some APs do not support 128-bit

encryption

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26

Keine Kommentare

Network-computing-devices Wireless Ethernet Adapter GW-EN11H Bedienungsanleitung Seite 19